Instructions / Assembly
Preparaon
Before beginning assembly, compare all parts with the Parts and Hardware lists. Be sure you have all the parts
and can identify them. A helping hand is always good. Assemble the patio heater with an adult assistant.
Use scissors to remove packaging from the parts. Do not use a box cutter as doing so may cut into the heater
and damage the nish. Do not discard any pieces. Use the appropriate tools to tighten all hardware.
Dispose of packaging materials properly. Please recycle whenever possible.
WARNING: While every precaution has been
made in the manufacture of this product,
care must be taken during assembly in case
sharp edges are present.
Please lay out all nuts and bolts
and check lengths before assembly.
Break down the packing carton to
use as a protective assembly surface.
Refer to the assembly diagrams
as necessary.
AA M6x12mm Bolt 8
BB M6 Nut 14
CC M8x16mm Bolt 3
DD M6x22mm Bolt 6
EE Spanner 1
Reector Stud 3
GG Wing Nut 3
HH Washer 6
II Anchoring Bracket 3
JJ Anchor 3
KK Nut Cap 9
LL Small Screw 9
MM Webbing 1
L
B
A
C
E
D
G
F
H
I
A Reector Panel 3
B Center Reector 1
C Head Assembly 1
D Post 1
E Tank Housing 1
Post Support 1
G Support Leg 3
H Base 1
I Wheel Assembly 1
L Cover 1
—
This item contains small
parts that can be swallowed.
Keep children away during
assembly.
WARNING
(not included)
Phillips Screwdriver
Page 5 / 15PH02 08/2021