Instructions / Assembly
Cleaning
PATIO HEATER
1. Before cleaning, ensure the heater is completely cool.
2. Check that the heater control is turned fully to the 'OFF' position.
3. Ensure the gas supply is shut o at the regulator or cylinder valve.
4. Disconnect the cylinder and place it away from the heater.
5. Check the burn tube to make sure it is clear and free of insects, spider nests, and other debris.
6. Use a soft, damp cloth to wipe down the outer surfaces of the heater.
7. Take care when washing the head assembly. Avoid getting water or cleaning solutions inside the unit.
8. Use a dry, soft cloth to dry the unit, if necessary.
Page 14 / 15
PH02 08/2021
This unit should be cleaned regularly to ensure safe use and extended product life. Never douse the heater with
water if its surfaces are hot.
NOTE: After repeated use, discoloration of the nishes may occur.
WARNING
DO NOT ALLOW WATER OR CLEANERS TO GET INSIDE THE UNIT!
Contact with water and cleaning solutions may damage the head assembly, ignition system,
and other internal components. Use extreme caution to avoid these areas when cleaning the unit.
PROTECTIVE COVER
Spot clean with a soft-bristle brush and lukewarm water. DO NOT USE SOAP OR DETERGENT as it may
damage the protective coatings added by the factory.
Air-dry only.
Do not pack away wet.
NOTICE