Instructions / Assembly

Page 3 / 5LW-DUCL 10/2020
STEP 5 I: 1 Q: 2 Y: 2 T: 2
Align the two holes on Center Front Axle Brace (I)
over the center of Bottom Frame (H). Secure by hand-
tightening 2x Hex Bolt (Q), 2x Washer (Y), and 2x
Lock Nut (T).
NOTE: the opposite end of the brace must be on top
of the front axle, as shown.
Place Yoke (K) onto the front axle so that the single
hole slides over the pre-attached bolt on Front Axle
Brace (L). Loosely secure by hand-tightening Washer
(Y) and Lock Nut (T).
STEP 6 K: 1 Y: 1 T: 1
STEP 7 P: 1 Y: 1 T: 1
Align the second hole of the yoke with the center front
axle brace and front axle. Secure by hand-tightening
Hex Bolt (P), Washer (Y), and Lock Nut (T).
Place Steering Connector (J) so the center hole is
underneath the outer hole on the yoke, but above the
holes on the front axle brace. Secure the components
by hand-tightening 3x Hex Bolt (Q), 3x Washer (Y),
and 3x Lock Nut (T).
STEP 8 J: 1 Q: 3 Y: 3 T: 3