Instructions / Assembly

2
Optional Wall Mount:
1. Place the bottom of the wall mount bracket against wall 17½ inch above where you want the bottom of the
fountain to rest on the wall. Make sure it is level.
2. Mark the holes in the bracket with a pencil.
3. Remove the wall mount bracket and drill starter holes (1/4 inch or 6mm) in your hole marks.
4. Hammer three wall anchors into the starter holes.
5. Replace the wall mount bracket and screw three wall screws into the wall anchors.
6. Lower fountain onto the wall mount.
Optional Cord Protectors:
1. Place the Cord Channel against the wall where you want the cord to go down the wall. Mark the top and
bottom hole with a pencil.
2. Remove the cord channel and drill starter holes (1/4 inch or 6mm) in your hole marks.
3. Hammer two wall anchors into the starter holes.
4. Replace the Cord Channel and screw two wall screws into the wall anchors.
5. Put the cord into the Cord Channel. Cover the Channel with one or both cords cover.
Troubleshooting:
Pump operates but no water flow: Make sure pump is fully submerged in water. If there is still no water flow, please
turn pump on then off several times.
Water speed: Adjust the switch control located on the pump housing.
Noise from pump/Fountain: Make sure pump is fully submerged in water.
Light does not shimmer: Check the light blub to make sure that it is connected to socket.