Instructions / Assembly

GSI-298

Warning

• Keep fountain out of reach of children.

• Use proper power source as indicated on water pump label.

• Keep electrical cords away from all heat sources. D not place electrical cords in high temperatures.

• Check water level at pump location regularly, avoid damage the pump must be fully submerged.

PARTS:

A. Basin -1pc

B. Pump and Transformer with finger light -1pc

C. Fountain body-1pc

D. Top lid -1pc

E. Pebbles-1 bag

F. Wall mount bracket- 1 pc

G. Wall Anchors- 5 pcs

H. Wall Screws- 5 pcs

I. Cord Channel- 1 pc

J. Cord Covers- 2 pcs

ASSEMBLY:

1. Insert the pump into the basin and connect the pump with the hose.

2. Put the fountain body into the basin and screw in.

3. Connect the transformer.

4. Insert the light into the top lid then put the lid on the fountain body and

screw in.

5. Place pebbles on top of the basin and spread out.

6. Fill with water, and then plug fountain into electrical outlet.

PAGE 1
GSI-298 Warning • • • • Keep fountain out of reach of children. Use proper power source as indicated on water pump label. Keep electrical cords away from all heat sources. D not place electrical cords in high temperatures. Check water level at pump location regularly, avoid damage the pump must be fully submerged. PARTS: A. B. C. D. E. F. G. H. I. J.
PAGE 2
Optional Wall Mount: 1. Place the bottom of the wall mount bracket against wall 17½ inch above where you want the bottom of the fountain to rest on the wall. Make sure it is level. 2. Mark the holes in the bracket with a pencil. 3. Remove the wall mount bracket and drill starter holes (1/4 inch or 6mm) in your hole marks. 4. Hammer three wall anchors into the starter holes. 5. Replace the wall mount bracket and screw three wall screws into the wall anchors. 6. Lower fountain onto the wall mount.