Owners manual

ASSEMBLY IN STRUCTIONS:

1 Place the Pedestal on the ground lift the Basin up and

find Arrow Mark and Button as picture(1) t hen set the Basin

on the Pedestal and make sure the button is closed tightly

Remove the pump from the package and untie the power code

Adjust the flow rate(if applicable) to the maximum(+) position

Pass the power cord through the middle of the Basin and Pedestal

then take the plug out as shown in picture(3)

Lift the Fountain Top up, through the water pipe from Middle

Pedestal find Arrow Mark and Button then connect them together

make sure the button is closed tight ly

Pick up the end of water pipe connect it with the pump and put

the pum p in the suitable location then close the cover

Fill water into Basin make s ure that water level c over the pump

fitly just completely

Connect the pump plug to a properly grounded grounding type

receptacle (GF CI) Processing circuit

①②

②

①

④

③