Owners manual

Cautions:
Use a proper power source as indicated on the pump label.
Keep the cord away from high temperatures and/or heat
sources.
Do not lift the pump by its power cord.
Keep the fountain out of reach of children.
Do not let the pump run dry. Pump must be completely
submerged for proper operation and cooling.
Do not pump heated liquids.
Operate with freshwater only. Avoid heavily chlorinated water
and water with high PH levels.
REMARK:
Please be sure that the assembly process is team works. Due
to the individual product designing difference, may have a gap
with specifications content more or less, we are sorry but we
cannot inform besides, understand please.
Diagram of water circulation for a whole unit fountain.
PUMP ASSEMBLY INSTRUCTIONS:
1. Remove the pump from the package and untie the power
cord. Adjust the flow rate (if applicable) to the maximum (+)
position.
2. Drag out one end PVC tube from the fountain back (as
shown in Fig.①.) to connect with the pump. Place the pump in
a desired location in the fountain. Close the cover plate (The
individual product is not with any cover plate because of
structure difference). Always keep the plug out.
3. Add water according to what picture shows. Make sure that
water level does not exceed the front and back rock bottom.
4. Connect the power cord from the pump to a properly
grounded, grounding type receptacle (GFCI). Processing
circuit.
Diagram of water circulation for one set fountain with two
pieces, by the perpendicularity links up.