SDS
Safety Data Sheet
(REFRIGERANT R600a - ISOBUTANE)
Material safety data sheet according regulation (UE) 2015/830
Version 4 – Date: May, 2019
Page
6
of 14
7. Handling and storage
7.1 Precautions for safe handling
Technical measures Use only properly specified equipment that is suitable for this product, its supply pressure and
temperature.
In case of doubt, refer to supplier's handling instructions.
Only experienced and properly instructed persons should handle gases under pressure.
Service technician must check regularly your entire gas system to ensure that it is leak-free.
Safe handling The substance must be handled in accordance with good industrial hygiene and safety procedures.
Refer to supplier's / manufacturer
’
s handling instructions.
Handle and open container with care. Caution when opening, pressurized container.
Protect from sunlight and do not expose to temperatures exceeding 50
°
C (122
°
F).
Do not spray on a naked flame or any incandescent material.
Do not use in area without adequate ventilation.
Protect containers from physical damage; do not drag, roll, slide or drop.
Do not pierce or burn, even after use.
Leave valve protection caps in place until the container is ready for use.
Close container valve after each use and when empty, even if still connected to equipment.
Do not remove or deface labels provided by the supplier for the identification of the container
contents.
Industrial hygiene Ensure adequate ventilation of the working area.
Do not drink, eat or smoke in the working area.
7.2 Conditions for safe storage, including any incompatibility
Requirements for storage areas and containers
Keep containers tightly closed in a dry, cool and well-ventilated place, away from any ignition or heat sources.
Store in original container.
Container valves or caps should be in place.
Post
“
No Smoking
”
signs in storage or use areas.
Incompatible materials
Avoid storage with oxidizing products, acids and, in general, with chemicals.
Avoid storage with tools or equipment that may cause sparks.
Electrical equipment should be non-sparking and explosion proof.
7.2 Specific end use(s)
For professional and industrial use only.