Use and Care Manual

ASSEMBLY
Page 2 / 3
Assembly Tip: Ensure all parts and
hardware align correctly before fully
tightening the lock nuts.
1. Slide Leg (C) into Bottom Pole (B).
Align the holes on the underside of
each piece. Hand-tighten Bolt (D)
and Washer (E). Repeat until all legs
are attached. Tighten all bolts using
Hex Key (X).
2. Slide Top Pole (A) onto Bottom Pole
(B) and align the holes. Secure the
poles by hand-tightening M8x55MM
hardware (F) through the top holes.
Repeat with the bottom holes. Fully
tighten the hardware using Hex Key
(X) and Spanner (Z). Place the hex
nut cap over the lock nut.
A
12/2019JYF19036 KD Bracket
D
X
E
1
X
Z
F
2
B
Cx4