Instructions / Assembly

JYF17043-set Page 3 / 4 02/2022
STEP 5
1: 1
2: 1
G1: 2
G2: 2
H: 8
P: 4
Q: 4
STEP 6
R: 1
S: 1
STEP 7
T: 1
STEP 8
3: 1
Align Chair Top (1)
with Chair Bottom (2).
As shown, hand-tighten M6x50mm Bolts (G2), Washers (H)
and Lock Nuts (P) to the outside mounting holes. Then, hand-
tighten M6x45mm Bolts (G1), Washers (H) and Lock Nuts (P)
into the center mounting holes.
Fully tighten hardware and place Nut Caps (Q) over the nuts.
Place Pin (R) into the top of the curved pole. Insert Extension
Spring (S) through the bottom of Pin (R).
Hang the egg chair on Extension Spring (S).
Wrap the hook and loop fastener that is sewn onto Strap (T)
around Pole (C). Loop the strap through the back of the egg
chair and connect the buckles, tighten strap as needed.
Tie Seat Cushion and Pillow (3) onto the frame of the egg chair.
NOTE: Do not tie cushions to the rattan material.
IMPORTANT:
Do not tie the
pillow or seat
cushion to the
rattan material,
as doing so may
cause the rattan
to break and
unravel.