Instructions / Assembly

Align Base Back (A), Base Front (B), Top Base Connector (E),
and Bottom Base Connector (F) and secure using Washer (H)
and M6x50mm Bolts (G2). Place Bolt Caps (I) on the bolt heads.
Carefully snap Foot (J) evenly onto the stand base, as shown.
IMPORTANT: If feet are not evenly distributed the stand could
tip over when in use.
Slide Straight Pole (C) into the back base and align the holes.
Secure the pole using M10x60mm Bolts (M), Washers (L), and
Lock Nuts (N) as shown. Place Large Hex Nut Caps (O) over
the lock nuts.
Page 2 / 4 JYF13103-set
Slide Curved Pole (D) onto Straight Pole (C) and align the
holes. Secure the poles using M10x50mm Bolts (K), Washer
(L), and Lock Nuts (N) as shown. Place Large Hex Nut Caps
(O) over the lock nuts.
02/2022
ASSEMBLY
STEP 1
A: 1
B: 1
E: 2
F: 2
G2: 8
H: 8
I: 8
STEP 2
J: 8
TIP: Ensure all parts align correctly before fully tightening hardware.
STEP 3
C: 1
L: 4
M: 2
N: 2
O: 2
STEP 4
D: 1
K: 2
L: 4
N: 2
O: 2
NOTE:
When installing a lock nut,

tighten until you feel resistance,

A wrench is required to tighten the
