User Manual

118
140
125
140
47
44
80
80
Auto Test
Button for testing the device's function for 5 seconds.
Button for testing the device's function for 30 seconds.
Button for testing the device's function for 60 seconds.
Button for turning on auto battery test system
Button for turning off auto battery test system
Button for canceling the test
The battery test is performed to help extend the operational lifetime of the battery, it will also test
that the unit is in good condition and ready for operation. If the test finds that the battery can supply
the unit with power for less than a designated amount of time, the red Charge LED will blinks
red 3 times every 2 seconds to indicate a Battery Testing Fault.
Dimension (mm)
Initial Trouble Shooting
Problem Cause What to do
- Power not getting to the unit
after plugging in. The LED AC
light does not turn on.
- Emergency light does not turn
on after the power went out.
- Emergency light only turns on
for a short time after the power
went out.
- The power socket might not have any
power.
- The plug or socket is loose.
- The AC.220V fuse is blown.
- Check the 220VAC power supply.
- Check the plug and socket.
- Contact customer service.
- The battery is not fully charged.
- The battery is past its operational
lifetime or has deteriorated
- Plug the unit in to charge the
battery for about 10 – 15 hours.
- Contact customer service to
replace the battery
- The ON switch was not pressed
- The lamp is faulty
- The circuit's wiring is loose.
- The DC fuse is blown
- Press the ON switch
- Contact customer service.
- Check the unit’s circuit connections
- Contact customer service.