Use and Care Manual

8
STEP 5:
NOTE: In order to properly tighten the seat, it is
important to note that you will need two open
faced wrenches (1 for each side) and will need
to tighten the nut on each side simultaneously
working in opposite directions of each other.
Loosen and remove the Adjustment Knob (No.
20). Next, insert the Seat Slider (No. 27) into the
Seat Post (No. 28) and adjust it to the desired
position. Re-insert and tighten Adjustment
Knob (No. 20) to secure the Seat Slider (No.
27) in place.
Attach the Seat (No. 26) to the Seat Slider (No.
27). Tighten and secure with Open Wrench (No.
13).
Attach the Handlebar (No. 23) to the Handlebar
Post (No. 22) using 2 Screws (No. 24) and 2
Washers (No. 25). Tighten and secure with
Allen Wrench (No. 11).
STEP 6:
Remove the preassembled 2 Screws (No.33)
and 2 Washers (No. 32). Then attach Water
Bottle Holder (No. 31) to Main Frame (No. 1)
using the 2 Screws (No. 33) and 2 Washers
(No. 32) that were just removed. Tighten and
secure with Spanner (No. 12).
The assembly is complete!