Installation Guide

7. Remove the M8 bolts (E4) on both sides with supplied wrench. Remove the metal limit rod (E1) from

the reel assembly (E). Roll the pulley to the far left of the plastic screw rod. Load the garden hose into

the pulley groove of the hose guide device. Pass the garden hose through the square retainer ring and

screw it to the hose connector on the reel.

5. Put the locknuts (Cc) into countersunk holes of the

hexagon nuts on the reel assembly (E). Pass the

round head hexagon bolts (Bb) through the holes on

the aluminum tube and the reel assembly (E), screw

them into the locknuts (Cc). Tighten all the 6 bolts.

6. Align the holes in the crank handle (A) with

the crank handle shaft on the reel assembly

(E). Insert 1 bolt (Aa) into the crank handle

and tighten with supplied wrench.