Mounting Instructions

© Exotronic, 2022 - not to be used or distributed without permission Page 9 of 19
Bottom of panel (regardless of junction box position).
Side view of panel with panel, showing double strips at top.
If your panel has the Junction Box on Top - Apply double-sided acrylic high bond foam tape to
both sides of the strips and attach to the panel (leave the top layer of red plastic intact for now).
Finger pressure must be used to push the tape into the surface to make sure that it has sufficient grip
on the surface for adequate bond strength.
If your panel has the Junction Box Under - Apply double-sided acrylic high bond foam tape to both
sides of the strips. You will need to use extra layers of tape to build up the area in which the junction
box sits. Do this by applying up to 2 layers of tape on each side of the strip (4 layers of tape total per
strip near the junction box). The tape will bond together. Once done, attach the strips to the panel
(leave the top layer of red plastic intact for now).