Mounting Instructions

© Exotronic, 2022 - not to be used or distributed without permission Page 8 of 19
STEP 3 Mount the panels using one of the following methods
Method 1 – Vented Gap Kit (Sunman eArc panels ONLY)
The Vented Gap Kit is available exclusively from Exotronic and consists of pre-cut strips of twin-wall
polycarbonate sheeting & VHB Tape.
How To:
Lay the panel face down on a soft surface (carpet, towel, etc.) and then line the strips into position.
The strips have been pre-cut to fit along with width of the panel and should be positioned so that
each strip runs in between each row of cells with the exception of the ends of the panel which have 2
strips each. Use a pencil or pen to mark where the strips will sit.
Top of panel with ‘Junction Box Under’ - Position strips around the junction box. Different panels will have slightly different
junction boxes, but the principle remains the same.
Top of panel with ‘Junction Box on Top’ – Position
2 strips at the top, then 1 strip every cell gap width for
the remainder of the panel.