Mounting Instructions

© Exotronic, 2022 - not to be used or distributed without permission Page 7 of 19
STEP 1 Clean and degrease the surface area
To ensure proper adhesion, all surfaces (mounting surface, back of panel and strips if being used)
must be cleaned and degreased. Not doing so will weaken the bond and can cause the bond to fail.
• Clean the surfaces with slightly soapy water to remove excess grime/dirt.
• Check the surface for any loose paint or blemishes, if required rub the mounting surface with
a fine or medium grit emery.
• Use a suitable degreasing product such as industrial alcohol or isopropyl alcohol.
STEP 2 Mark the position of panels accurately
Check measurements and if needed, mark the position of the panels ensuring there is no overlap.