Instructions / Assembly

ManualsBrandsSunlite ManualsCommercial Lighting12.6 in. 400 Watt Equivalent Integrated LED Dimmable Black High Bay Light, 5000K

D 10.8 INCH

H 4.6INCH

Black/White - Vaux (12V)

Purple - Dim +

Grey - Dim -

0(1)-10V

Dimmer

100W/150W

LED UFO HIGH BAY FIXTURE | 89780-SU, 89781-SU, 89782-SU

Black (or brown) line Connect Live Wire

White (or blue) line Connect Neutral Wire

Green (or yellow-green) line Connect Earth Wire

( 0-10V Dimming Wiring)

D 12.6 INCH

H 5 INCH

200W

DIMMABLE

Compatible with most wall based 0-10V dimming controllers

WARNINGS & CAUTIONS: Risk of ﬁre or electric shock, avoid ﬁre or electric shock. Turn oﬀ the power at fuse or circuit breaker box before installation and maintenance to

avoid electric shock. Before installation thoroughly review encolsed installation manual. Suitable for 120-277 Volt fused circuits,This product must be installed in

accordance with the applicable installation code by a person familiar with the construction and operation of the product and the hazards involved. If you do not have

suﬃcient electrical wiring experience, please consult a qualiﬁed electrician. Consult a qualiﬁed electrician to ensure correct branch circuit conductor. Do not make or alter

any open holes in an enclosure of wiring or electrical components during installation. Please wear gloves to avoid injury before installation. If the product is damaged, do

not attempt installation and do not use. Not for emergency lighting. please use listed water proof strain relief bushing when connecting the supply cord to the outlet box.

Operating temperature -40°C - 50°C(-40°F - 122°F). Suitable for wet locations.

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interence, and (2) this

device must accept any inteference received, including that may cause undesired operation.

Installation Methods: Hook Mount (Ceiling Mount and 1/2” NPT Mount are optional.)

1. Turn power OFF from the electrical panel before starting installation.

2. Carefully remove the ﬁxture from the carton, and check that all parts are included, as shown in ﬁgure.

Hook Mount

WIRING INSTRUCTION OF MAIN CABLE:

1. Screw the hook into the ﬁxture, tighten and ﬁx it. (Fig. 1)

2. Hang the ﬁxture on the ceiling hook or chain. (Fig. 2)

3. After installation, connect the wire of the ﬁxture to the mains according to local wiring

rules, ensure the connection is stable and protected on the connection.

4. Restore power at fuse or circuit breaker box.

Installation

Fig. 1

Fig. 2