Installation Guide

Align knockout hole with the supply wire location on the mounting
surface and hold the housing base (B) up in its intended location with one
hand while marking the location of the two keyhole slots at each end of
the fixture plate. see Fig 3.
STEP 4.
Feed the supply wires from the mounting surface through the knockout
hole one the housing base (B). Guide the heads of the two wood screws
into the keyhole slots and slide the housing base (B) in the direction such
that the wood screw heads rest over the narrow part of the keyhole slot.
Ensure that the fixture is supported and tighten the two wood screws (CC)
until the fixture is secured to the mounting surface. see
Fig 5.
STEP 6.
Connect the fixture wires to the supply wires -- black to black, white to
white and green to copper/bare.
WARNING: if there is no ground supply wire, stop installation and consult
a qualified electrician. once wire connections are made, secure each with
a wire nut (BB). see
Fig 6.
STEP 7.
DRYWALL MOUNTING: if the mounting holes go through drywall without a
stud, drill four small pilot holes using a 1/8in. drill bit (not included), and
install drywall anchors (AA) into the holes with a hammer (not included).
CEILING STUD MOUNTING: if the mounting holes go through ceiling studs,
drill four small pilot holes using a 5/32in. drill bit (not included) for the
wood screws (CC).
Note: install Wood screws (CC) but leave about 1/2in. of space between
the screw head and mounting surface. see
Fig 4.
STEP 5.
3
4
5
6
Snap the LED cover assembly (A) back onto the housing base (B) to
complete the installation. Fig 7.
STEP 8.
7
WIRING DIAGRAM
0-10V DIM
DRIVER
White=Neutral wire
Purple+
Pink-
Red+
Black-
+
30K-
LED
Load
50K-
B lac k=Line wire
LED WIRING DIAGRAM
0-10V DIMMING CONTROL WIRING DIAGRAM
0-10V DIM
DRIVER
Brack
White=Neutral wire
Purple+
Pink-
Red+
Black-
+
30K-
LED
Load
50K-
Brack=LINE WERE
RED
Purple+
Gray-
0-10V DIM
DRIVER
B l ack
White=Neutral wire
Purple+
Pink-
Red+
Black-
+
30K-
LED
Load
50K-
B l ack=LINE WERE
RED
Purple+
Gray-