Instructions / Assembly

LED POST TOP LIGHT INSTALLATION INSTRUCTIONS

IMPORTANT

READ CAREFULLY BEFORE INSTALLING FIXTURE. RETAIN THESE INSTRUCTIONS FOR FUTURE

REFERENCE

Fixtures must be wired in accordance with the National Electrical Code and all applicable local codes. Proper

grounding is required for safety. THIS PRODUCT MUST BE INSTALLED IN ACCORDANCE WITH THE APPLICABLE

INSTALLATION CODE BY A PERSON

FAMILIAR WITH THE CONSTRUCTION AND OPERATION OF THE PRODUCT AND THE HAZARDS INVOLVED.

WARNING: Make certain power is OFF before installing or maintaining fixture. No user serviceable

parts inside.

FIXTURE ASSEMBLY

POLE MOUNTING

1. Feed the (3) Housing wires through one of the three

Rods.

2. Screw the top of (3) Rods into the Housing. Be sure the

Housing clips are properly engaged onto the Rods.

3. Feed Fixture Wires through the Tenon Pole Adaptor.

4. Slide Tenon Pole Adaptor on three Rods. Be sure the

notches face the inside of the Tenon Pole Adaptor.

5. Put the Rubber mat into the Adaptor

6.Tighten the (3) Set Screws at the Tenon Pole Adaptor to

secure Rods.

1. Make the wiring connections with UL approved

connectors knot the wires for strain relief.

2. Tenon Pole Adaptor can fit tenon with 3” or 2 3/8”

diameter. Slip Tenon Pole Adaptor over tenon. For 3”

tenon use shorter (3/8”) tenon set screw and for 2 3/8”

tenon use longer (7/8”) tenon set screws to secure the

fixture to the tenon.

Tenon Pole Adaptor

Rods (3)

Housing

Housing Wires

Set Screw

Rubber mat

Screws

PAGE 1
LED POST TOP LIGHT INSTALLATION INSTRUCTIONS IMPORTANT READ CAREFULLY BEFORE INSTALLING FIXTURE. RETAIN THESE INSTRUCTIONS FOR FUTURE REFERENCE. Fixtures must be wired in accordance with the National Electrical Code and all applicable local codes. Proper grounding is required for safety. THIS PRODUCT MUST BE INSTALLED IN ACCORDANCE WITH THE APPLICABLE INSTALLATION CODE BY A PERSON FAMILIAR WITH THE CONSTRUCTION AND OPERATION OF THE PRODUCT AND THE HAZARDS INVOLVED.
PAGE 2
WIRING Universal voltage driver permits operation at 100V 0-10V DIMMABLE WIRING to 277VAC, 50 or 60Hz except fixtures factory Universal voltage driver permits operation at 120V thru ordered with a 120V photocell (/PC). 277V, 50 or 60 Hz. For 0-10V Dimming, follow the wiring 1. Connect the black ﬁxture line to the (L) Live line directions as in fig. 4. supply wire. 1. Connect the black fixture lead to the (+) LINE supply 2. Connect the white ﬁxture line to the (N) Neutral lead. line supply wire.