Instructions / Assembly

ManualsBrandsSunlite ManualsLighting10 in. Dimmable Energy Star LED Wall Sconce with Brushed Nickel and Half Cylinder White Acrylic Shade, Cool White 4000K

Installation

INSTALLATION INSTRUCTIONS

49137-SU | LFX/HC/BN/23W/E/30K | LED HALF CYLINDER WALL SCONCE

49138-SU | LFX/HC/BN/23W/E/40K | LED HALF CYLINDER WALL SCONCE

Please read and understand this entire manual before attempting to

assemble, operate or install the product.

WARNING: Avoid re or electric shock. Follow installation instructions carefully.

If unsure about electrical installation, consult, a qualied electrician. Wear

rubber-soled shoes and work on a sturdy wooder ladder. Ground xture to

avoid potential electric shock. Handle metal parts carefully to prevent cuts. To

avoid a hazard to children, account for all parts and destroy all packing material.

This product is only suitable for indoor wall-mounted applications. Suitable for

damp locations.

CAUTION: Turn o the power at fuse or circuit breaker box before installation

and maintenance. NOTE: This xture is suitable for 120-Volt fused circuits.

Fixture must be installed according to National Electric Code and local building

codes. If you are unsure about wiring, consult a qualied electrician. THIS

FIXTURE BODY IS ONE PIECE, DO NOT DISASSEMBLE OR MAKE ALTERATIONS.

This device complies with part 15 of the FCC Rules. Operation is subject to

the following two conditions: (1) this device may not cause harmful

interence, and (2) this deivce must accept any interence received,

including that may cause undesired operation.

This xture may not be compatible with all dimmers. Please visit

www.Sunlite.com/Dimmers for dimmer compatiblity information.

DIMMABLE

BEFORE PROCEEDING, PLEASE ENSURE POWER HAS BEEN SWITCHED OFF!

STEP 1. Remove the diuser lens by sliding it out of the xture. Fig. 1

STEP 2. Slip wires from juction box through the baseplate. Install baseplate to juction box with included screws. Fig. 2

STEP 3. Connect xture wires to those in the junction box using the included wire nuts (L to L, N to N, G to G). Fig. 3

STEP 4. Tuck wires into junction box and place the center of the xture over the baseplate. Fasten mounting screws through the xture into baseplate. Fig.

STEP 5. Insert diuser lens and switch power on.

Fig. 1 Fig. 2 Fig. 3 Fig. 4

Sunshine Lighting Company

744 Clinton Street Brooklyn, NY 11231, USA

T. 718.768.7000

F. 718.768.0970

www.sunlite.com