Installation & Assembly

February 16 Made in China 7 / 12

Step5. Install Post

Install Post on Table Top Base by using 6 bolts (LA),

6 nuts (LB) and 6 washers (LG).

Step6. Install Table Top & Table Top Décor

Carefully install Table Top on Table Top Base by

using 6 screws (LC) and 6 washers (LH).

Put down Table Top Decorative through Post on

Table Top.

Step7. Attach Dome Brim to burning system

Attach Dome Brim to burning system by using 16

screws (LF) and 16 cap nuts (LI), cap nuts on the

upper dome cover.

Step8, Attach Post Décor

Attach Post Decorative piece to Engine by fastening

screw (LJ).

Step9. Install gas assembly

Insert gas line through Post and slide fixing end of

Engine into Post, align/place control knobs of

Engine and labels of Post at the same side and

fasten with 3 screws (LE).

Warning: The upper frame is heavy; assistance

may be needed for this step.

Step10. Connect Regulator and Gas Line

Hand screw coupling of regulator hose into coupling

of connector hose. Tighten fully using 2 adjusting

wrenches.

Fig.10

Fig.12

Fig.11

.8Fig.7

Fig.9