Installation Guide

Page 1 of 4 Version: 8912 Made in China
L-AB067PST
ASSEMBLY INSTRUCTIONS
Read all instructions before assembly and using this
product.
Care & Maintenance
Our iron components for garden accessories and furniture are finished
using a powder coating process that protects it from rusting. However,
due to the nature of iron, surface oxidation (rusting) will occur if these
protective coatings are scratched. This is a natural process and is not a
defect. To minimize this condition, use care when assembling & handling
the product to prevent scratching the paint. Should any scratching or
damage occur, immediately touch-up with rust inhibiting paint, which is
readily available at local hardware stores. Surface rust. Surface rust can
be removed easily using a very light application of common cooking oil.
If surface oxidation (rusting) occurs and no measures are taken to
correct it, the oxidation may start dripping onto the deck or patio, which
may cause damaging stains that, may be difficult to remove.
Some parts may contain sharp edges. Wear protective gloves if
necessary.
Do not play with the construction of the pillar.
Select ideal location. Set out all parts on a clear and level surface prior
to assembly. Ideally, the pillar frame should be set up in its desired
location to avoid moving it after assembly.
Tools and Assistance. Ladder and screw driver are self-provided.
Whenever possible, assistance is preferred.
Check for damaged parts. Before assembling your pillar, check for damaged parts, any part that appear
damaged should be carefully checked to determine that it will be operated properly and perform its
intended function. Any part that is damaged should be properly repaired or replaced by a qualified
technician.
Refer to assembly diagram. During assembly, it will be helpful to referring to the assembly diagram.
Keep children away. Children must never be allowed in the work area. Do not let them handle parts and
tools. No people will be permitted to enter into work area except who is working.
In order to reduce the risk of personal injury and damage to equipment, basic safety precautions should
always be followed when assembling and using this product.
Begin the assembly at least 6 feet away from any obstruction, such as a fence, garage, house,
overhanging branches, laundry line, or electrical wires.
Install this pillar on level ground. This pillar cannot be permanently staked or attached to a concrete floor or
platform. This pillar is intended for decorative purposes only, and is not designed to withstand harsh
weather, including high winds, rain, and snow.
Verify that all nuts and bolts are tightly secured before and during use.