Assembly Instructions D-AB001PWI Parts List Parts Parts Description Qty A Arch top beam 2 2 B Top support beam 3 C Arch top beam 1 2 D L shape connector 2 E Seat back 1 F Seat Board 1 G Screen 2 AA Bolt M6*32 20 BB Bolt M6 8 CC Allen KeyM6 1 DD Wrench M6 1 EE Flat Washer 28 FF Plastic cap 8 Number
Step 1. Insert Arch top beam 2 (A) into (C), then connect them by Bolt M6*32 (AA), flat washer (EE) as Fig.1 shown. Step 2. Connect Top support beam( B) and Arch top beam 2(A) and Arch top beam 1(C) by Bolt M6*32 (AA), flat washer (EE) as Fig.2 shown. Step 3. Connect the back of Seat Board (F) and Screen (G) by Bolt M6*32(AA), flat washer (EE) as Fig.2 shown. Step 4. Connect the front of Seat Board (F) and Screen (G) by Bolt M6*32(AA), flat washer (EE) as Fig.3 shown.
Step 5: Connect the bottom of Seat Back (E) and Screen (G) by Bolt M6*32 (AA) and flat washer(EE) as Fig.5 shown. Step 6. Connect the upper of Seat Back(E) and Screen(G) through L shape connector (D)by Bolt M6*32(AA) flat washer(EE),Bolt M6 (BB) and plastic cap(FF) as Fig.6 shown. Step 7. Connect Arch top beam 2 (A) and Arch top beam 1 (C) to Screen(G) with Bolt M6*32(AA), Bolt M6(BB), flat washer(EE) and plastic cap(FF) as Fig.7 shown. All bolts can be tighten up by Alley Key M6 and Wrench M6(CC/DD).
6. Do not leave the arbor assembled when there is a risk of high wind, as possible damage will occur to the structure. 7. Do not climb on the arbor. Falling off the arbor can result in serious injury, possibly even death. Limited Warranty: This limited warranty is extended to the original purchaser and applies to defects in materials and workmanship of your item provided the item is maintained with care and used only for personal, residential purposes.
