Instructions / Assembly

No assembly is needed for the table; simply open the

table as shown below.

Step 3:

Firstly, insert Steel plugs (GG) into the hole of chair back

(A), then, connect connector (F) and chair back (A) by

with bolts (DD), flat washers (EE), nuts (FF) and

screwdriver (not included) and wrench (HH), don’t

tighten them in this step.

Step 4:

Firstly, insert Steel plugs (GG) into the hole of chair back

(A), and then, connect chair back (A) and left leg / right leg

(D1/D2) by with bolts (DD), flat washer (EE) and

screwdriver (not included) as Fig 1, don’t tighten bolts.

Connect left arm / right arm (D1/D2) and left leg / right leg

(C1/C2) by with bolts (CC), flat washers (EE), nuts (FF)

and screwdriver (not included) and wrench (HH) as Fig 2.

Last, tighten all bolts.