Replacement Part List

M6 Washer

16 PCS

M6 Nut

8 PCS

M6*40 Flat Bolt

8 PCS

Hardware Pack 2

Fig.4: Use Bolt (CC) and Washer (BB) to fasten the Beams(E1,E2) on the Posts(D1,D2,D3), then use Bolt (II) and

Washer (BB) to fasten the Beam Support Tube (E3) on the Beam (E1, E2).

Fig.5: Firstly inset the Tabletop (I) connector into the U plate on the Posts (D2, D3). Then use Bolt (CC) and

Washer (BB) to fasten the Tabletop (I) on the Post (D2, D3).

Fig.6: Use Bolt (CC) and Washer (BB) to fasten the Tabletop Ssupport (J) beneath the table.

Fig.1: Firstly attach the bottom of Posts (D1,D2, D3) into Stake Cover(A) and raise them up. Then use Bolt (AA) and

Washer (BB) to fasten the Stake Plate(C) on the bottom of posts.

Fig.2: Attach the Short Beam (E1) with Long Beam (E2) tightly using Bolt (CC) and Washer (BB).

Fig.3: Use Bolt (AA) and Washer (BB) to fasten the Middle Beam Connector (F) on the assembled beams.