Replacement Part List

7 / 9

Fig.9：Insert the upper end of the Middle beam (G) into the tube of Long side of the large top (H).

Fig.10：Attach the lower end of the Middle beam (G) into the Middle beam connector (D) by using Bolt

(EE), Washer (BB) and Nut (DD).

Fig.11：Insert the Slanting bar of the small top (J) into the Small top connector (K), then screw the

Hook(E) to the Small top connector (K),

Fig.12：Lay the Big canopy (R) and then Middle canopy(Q) on the

top，and do not spread them at this time ,then attach the

assembled small top to the big top connector (I) by putting

the tube of the slanting bar(J) into the tube of the big top

connector (I).

Hardware Pack 3

Description

Part#

Label

Qty

Image

Stakeφ 8*180

DD08180C

Plastic ring

R40U

112

Fig.6：Assemble the Long side of the large top (H) and Large top connector (I) by using Bolt (AA)

and Washer (BB).

Fig.7：Insert the upper end of the Slanting bar (F) into the tube of Large top connector (I)

Fig.8：Attach the lower end of the Slanting bar (F) in to the Post (A) by using Bolt (EE), Washer

(BB) and Nut (DD).