Installation Guide

5 / 8
Fig.3：Attach the Long horizontal screen (B) and Short horizontal screen (C) to the Post (A) by using Bolt (CC)
and Washer (BB).
Fig.4-1：Attach the slanting support slate (O) to the screen(B、C) by using Bolt( CC) and Washer(BB).
Fig.4-2：Attach the Slanting bar connector (D1) to the Post(A) by using Bolt(AA)and Washer(BB).
Fig.5：Attach the Mosquito netting bar (N) to the Long horizontal screen (B) and Short horizontal screen (C)
by using Bolt (AA) and Washer (BB).
Hardware Pack 2
AA M6X20 Bolt 16 PCS
BB M6 Washer 32 PCS
EE M6X35 Bolt 8 PCS
DD M6 Nut 8 PCS
Fig.6：Assemble the Long side of the large top (H) and Large top connector (I) by using Bolt (AA)
and Washer (BB).
Fig.7：Insert the upper end of the Slanting bar (F) into the tube of Large top connector (I)
Fig.8：Attach the lower end of the Slanting bar (F) in to the Post (A) by using Bolt (EE), Washer
(BB) and Nut (DD).