Use and Care Manual

6 / 8

Stake φ8*180

16 PCS

Plastic ring

120PCS

Hardware Pack 2

Fig.9：Attach the Slanting bar2 (F) to the Post 1(A1) by using Bolt (CC), Washer (BB) and Nut(DD).

Fig.10：Insert the Middle beam 1(G) into the Middle beam 2(H).

Fig.11：Insert the Middle beam 1 (G) into the tube of the Long beam of the large top (J) and Short

beam of the large top (K).

Fig.12：Assemble the Middle beam 2 (H) to the Middle beam connector (I) by using Bolt (CC), Washer

(BB) and Nut (DD).

Fig.13：Insert the Slanting bar of small top (M) into the Small top connector (N).

Fig.14：Put the Large canopy (R) on the large top, do not open it now, then insert the Slanting bar of

small top (M) into the Connector (L).

Fig.15：Screw the Hook (P) to the Small top connector (N).