Use and Care Manual

4 / 8
Fig.1: Fit the Base protector (B) onto the Post (A), connect the Post base (C) and post (A) by using bolt (AA) and
flat washer (BB).
Fig.2: Fix the Conner decor block (J) onto the top of the post (A) by using bolt (AA) and flat washer (BB).
Fig.3: Insert the Long panel 1 (D1) into Long panel 2 (D2), fix them by using bolt (CC) and flat washer (BB).
Connect the Short panels (E1 & E2) in the same way. (Please note the screw position.)
Hardware Pack 2
AA
M6*15 bolt
4PCS
BB
M6 flat washer
28 PCS
CC
M6*15 bolt
16 PCS
DD
M6*25 bolt
8 PCS
Fig.4: Fix the Mid top bar connector (I) on the middle of the panels (D1 & D2 / E1 & E2) by bolt (CC) and washer
(BB).
Fig.5: Fix the long netting bar (O1) to long panels & short netting bar (O2) to short panels by using bolt (AA) and
flat washer (BB).
Fig.6: Fix the assembled panels to the post (A) by using bolt (DD) and flat washer (BB).