Assembly Instructions Item#D-GZ399PST-K 1/8
Parts List Post A 4 Base protector B 4 Post base C 4 Long panel (1) D1 2 Long panel (2) D2 2 Short panel (1) E1 2 Short panel (2) E2 2 Slanting bar F 4 Short mid top bar G1 2 Long mid top bar G2 2 H 4 I 4 Conner decor block J 4 Small top connector K 1 Small top bar (1) L1 2 Small top bar (2) L2 2 Pothook M 1 N1 2 N2 2 Slanting bar Connector Mid top bar connector Long panel of top frame Small panel of top frame 2/8
Long netting bar O1 4 O2 4 P 1 Q 1 R 1 S 1 T 1 Short netting bar Top Finial Small canopy Large canopy Wall Mosquito netting Hardware Pack 1 AA BB CC DD W M6*15 bolt M6 flat washer M6*15 bolt M6*25 bolt 32 PCS 64 PCS 16 PCS 16 PCS M6 wrench 1 PC 3/8
Fig.1: Fit the Base protector (B) onto the Post (A), connect the Post base (C) and post (A) by using bolt (AA) and flat washer (BB). Fig.2: Fix the Conner decor block (J) onto the top of the post (A) by using bolt (AA) and flat washer (BB). Fig.3: Insert the Long panel 1 (D1) into Long panel 2 (D2), fix them by using bolt (CC) and flat washer (BB). Connect the Short panels (E1 & E2) in the same way. (Please note the screw position.) Fig.
Fig.7: Fix Small panel of top frame (N2) to Long panel of top frame (N1) by using bolt (DD) and washer (BB). Fig.8-1:Insert Slanting bar (F) to Slanting bar Connector(H) Fig.8-2: Fix Slanting bar (F) to the top of Post (A) by using bolt (AA) and washer (BB). Fig.9:Attach Slanting bar Connector (H) to the corner of the top frame (N1 & N2) by using bolt (CC) and washer (BB). Fig.10: Insert Long mid top bar (G1) and Short mid top bar (G2) into the mid top bar connector (I). Fig.
Fig.16: Spread the Large canopy (R), hang the pothooks of the large canopy into the holes on the panels. Fig.17: Hang Mosquito netting (T) on the inside netting bar (O1 & O2) by using the Plastic ring (FF). Wall (S) on the outside. Fig.18: Fix the assembled gazebo with Peg (EE).
IMPORTANT: 1. Keep all children and pets away from assembly area. Children and pets should be supervised when they are in the area of gazebo construction. 2. The area for assembly should not be less than 6 feet from any obstruction such as fence, garage, house, overhanging branches, laundry line or electrical wires. 3. This unit is heavy. Do not assemble this item alone. Six people are recommended for safe assembly. 4. Some parts may contain sharp edges. Wear protective gloves if necessary during assembly.
Maintenance: Our iron/steel components for garden accessories and patio items are coated with rust inhibiting paint that protects it from rusting. However, due to the nature of iron, surface oxidation (rusting) will occur once these protective coatings are scratched. This is a natural process and is not a defect! To minimize this condition, we recommend care when assembling & handling the product to prevent scratching the paint.
