Use and Care Manual

Fig.1: Slip base protector (M) over post (K) and connect base (L) and post (K) with screw (AA) and

flat washer (BB).

Fig.2: Attach Corner decorative part (J) and Top slanting beam connector (F) to post (K) with screw

(AA) and flat washer (BB).

Fig.3: Insert screen(1) A1 to screen(2) A2,tighten with bolt (CC) and flat washer (BB), then secure

middle top beam connector (G2) between screen(A1) and screen (A2).(Copy above step to

assemble screen (B1), screen B2 and middle top beam connector (G1).)

Fig.4: Attach misquote netting bar (N1, N2) to screen with screw (AA) and flat washer (BB)

Fig.5: Attach the assembled screen to post (K) with bolt (DD) and flat washer (BB).

Φ1/4" Flat washer

4 PCS

1/4"-20 Nut

4 PCS

1/4"-20*1.4 Screw

4 PCS

Hardware Pack 2