Owner's Manual

11
14. Check that the electrical supply voltage and frequency
(Volt/Hz)correspondtothosespeciedonthepressure
washer rating plate. If the power supply is correct, you
may now plug the pressure washer into the power outlet
(Fig. 15).
NOTE: TheGFCImayneedtoberesetwhenrstplugged
into the electric outlet. Press the "Reset" button until the
power light indicator on the GFCI illuminates.
Operation
mIMPORTANT! This pressure washer is equipped with
amicro-switchsensitivetowaterow.ThisTotalStopSystem
(TSS)senseswaterowinthepump.Whenthetriggeris
released,waterstopsowingthroughthepump.TheTSSthen
automaticallyturnsthemotorotoprotectthepumpfrom
overheating, thus saving energy and prolonging pump life.
1. Turn the water supply tap on completely.
2. Make sure the safety lock is down and in its original
position (Fig. 16), then press the trigger for a few seconds
untilwaterowissteady.Thiswillallowairtoescapeand
discharge any residual pressure in the hose.
3. Turn the switch to the ON (I) position to start the pressure
washer (Fig. 17).
Using the Nozzles
Before beginning any cleaning task, determine the best nozzle
forthejob.Eachofthenozzleshasadierentspraypattern.
Thenozzlepatternsare40˚(forgentlecleaning),25˚(forall-
purposecleaning),15˚(fortoughjobs),andthe0˚(forspot
cleaning or hard-to-reach areas).
mCAUTION! NEVER change nozzles without locking the
safety lock on the trigger handle.
mWARNING! High-pressure jets can be dangerous if
subject to misuse. The jet must not be directed at persons,
pets, live electrical equipment, or the appliance itself.
This electric pressure washer is equipped with four (4) Quick-
Connect nozzles that easily snap onto the Quick-Connect
collar of the stainless steel lance.
Toconnectanozzletothestainlesssteellance:
1. Turnothepressurewasherandshutothewatersupply.
Pull the trigger to release water pressure.
Fig. 14
On/Oswitch
RESET
TEST
Fig. 15
GFCI
Power light
indicator
Reset
Fig. 16
Safety lock
Slot
Trigger
Fig. 17