User`s manual

___________________________________________________________________________________
23
Configure COM / LPT Port Settings
After the board drivers are installed, please refer to following instructions to
configure Serial COM and Parallel LPT port settings.
(1) Please launch the “Device Manager”.
(2) Right click the “SUNIX 2-port RS-232 Serial Card / 1-port Parallel
Multi-IO Card” item from the “Multifunction adapters” sub-tree and click
“Properties”.
(3) On the “Port Control” tab, select a port to configure. You can set both
COM and LPT ports settings through this page.
* Click “OK” to approve the settings for the selected port.
* Click “Apply to All” to approve the settings for all COM and LPT ports.