User's Manual

SUNITEC ENTERPRISE CO.,LTD www.sunitec.com
off. Meanwhile, a short beep comes up.
(C) To Use headset:
Once pairing is successful, this unit is under stand-by mode and ready for Bluetooth communication. Please
locate this unit within 10 meters (max.) to phones.
(a) To Answer a Call:
When a call is in, a ringing tone will come out of headset. Press function key, up & down, to answer a call.
(User may press phone key to answer, too.) Once it's under talking status, green LED blinks twice every 1.5
seconds.
(b) Not to Answer a Call:
When a call is in, a ringing tone will come out of this unit. If user doesn't intend to answer this call, constantly
press function key, up & down, for 3 seconds until ringing tone is off.
(c) Dialing out:
After pairing is done, user may dial out numbers through phones and press function key, up & down, then talk
through this unit. During conversation, green LED blinks once every 1.5 seconds.
(d) Voice Activation:
To voice dialing, under stand-by mode, press function key to enter into Bluetooth connection mode - green LED
blinks once every 1.5 seconds with a short beep coming out of earpiece. User may talk to mic. of this unit for
voice dialing. If it's successful, green LED stays blinking every 1.5 seconds. If not successful, this until will
resume back to stand-by mode - green LED blinks once every 4 seconds. Users are recommended to refer to
voice dialing procedure of individual phone.
(e) Volume Adjustment:
Simply adjust the function key, left & right, to adjust volume.
(D) LED Indication (Single LED, Bi-Colored.)
Status
LED Indication
Operation Battery Normal Battery Low
Power OFF
LEDs OFF LEDs OFF
Stand-By
Green LED blinks once every 4 seconds Red LED blinks once every 4 seconds
Incoming Calls
Green LED blinks twice every 1.5 seconds Red LED blinks twice every 1.5 seconds
Outgoing Calls
Green LED blinks once every 1.5 seconds Red LED blinks once every 1.5 seconds
Red LED blinks once every 0.5 seconds
Charging:
Under Charge
Fully Charge
Green LED blinks once every 0.5 seconds
Red & Green LEDs Blink in turn
Pairing:
Processing
Successful
Green LED blinks once every 4 seconds Red LED blinks once every 4 seconds
(E) Function Key:
(a)Short Press:
To change from stand-by mode into automatic Bluetooth connection mode, vice versa.
(b)
Constant 3-second Press:
To change from stand-by mode into off mode.
To change from paired mode into off mode.
(c)Constant 5-second Press:
To change from off mode into stand-by mode
(d)Constant 7-second Press:
To change from off mode into pairing mode