PHSQSS -TT PHSQSS-TT
WARRANTY CARD CONTENTS Specifications……………………………………...3 Product Features…………………………………...3 Introduction………………………………………..3 Parts and contents…………….……………………4 Safety Information ……………….…………….….5 Preparation………………………………………5-6 Warnings…………………………………….…...7-8 Assembly Instructions………………….………8-10 Operation Instructions………….……………..11-15 SUNHEAT International 3724 Arch Ave. Grand Island, NE 68803 1-877-467-8643 TO REGISTER WARRANTY ONLINE OR FOR DEALER INQUIRIES GO TO WWW.SUNHEAT.
PARTS and CONTENTS TROUBLESHOOTING PROBLEM Reflector X1 Mesh x1 Damper x1 Support x4 Protective Guard x4 Glass Tube x1 Pilot won’t light Note: Heater operates at reduced efficiency below 40ºF (5ºC) POSSIBLE CAUSE CORRECTIVE ACTION Cylinder valve is closed Open valve Blockage in orifice or pilot tube Clean or replace orifice or pilot tube Air in gas line Open gas line and bleed it (pressing control knob in) for not more than 1-2 minutes or until you smell gas Low gas pressure with cylinder valv
SAFETY INFORMATION Storage Between uses: Turn control knob OFF. Disconnect LP cylinder Store heater upright in an area sheltered from direct contact with inclement weather (such as rain, sleet, hail, snow, dust, and debris). If desired, cover heater to protect exterior surfaces and to help prevent build-up in air passages. Note: Wait until heater is cool before covering During periods of extended inactivity or when transporting: Turn control knob OFF.
PREPARATION CONTINUED After Operation Store the appliance indoors only if the cylinder is disconnected and removed from the appliance. A cylinder must be stored outdoors in a wellventilated area out of the reach of children. A disconnected cylinder must have dust caps tightly installed and must not be stored in a building, garage or any other enclosed area. Use the pressure regulator supplied with the appliance. 1. 2. 3.
When the heater is ON: The flame should be blue with straight yellow tops. If excessive yellow flame is detected, turn the heater off and consult “Troubleshooting” on page 14 Re-lighting: Note: For your safety, control knob cannot be turned OFF without first depressing control knob in PILOT position and then rotating it to OFF. 1. Turn control knob to OFF 2. Wait at least 5 minutes to let gas dissipate before attempting to relight pilot 3. Repeat the “lighting” steps on prior page. Shut Down: 1.
DANGER (1) Failure to comply with the precautions and instructions provided with this heater can result in death, serious bodily injury, and property loss or damage from hazards of fire, explosion, burn, asphyxiation, and/or carbon monoxide poisoning. Only persons who can understand and follow the instructions should use or service this heater. (2) Never store propane near high heat, open flames, pilot lights, direct sunlight, other ignition sources or where temperatures exceed 120 degrees F (49 degree C).
OPERATION INSTRUCTIONS continued Caution: Do not attempt to operate until you have read and understand all general safety information in this manual, all assembly is complete, and leak checks have been performed. Before Turning Gas Supply ON: 1. Your heater was designed and approved for outdoor use only. Do NOT use it inside a building, garage, or any other enclosed area. 2. Make sure surrounding areas are free of combustible materials, gasoline, and other flammable vapors or liquids. 3.
ASSEMBLY INSTRUCTIONS CONTINUED Use the pressure regulator supplied with the appliance. The installation must conform with local codes, or in the absence of local codes, with National Fuel Gas Code, ANDZ223.1/NFPA54, Natural Gas and Propane Installation Code, CSAB149.1, or Propane storage and handling code, B149.2.
