Owner's Manual

CARE AND MAINTENANCE

• Spiders and insects can nest in burner or orifices. This dangerous condition can damage heater

and render it unsafe for use. Clean burner holes by using a heavy-duty pipe cleaner. Compressed

air may help clear away smaller particles.

• Carbon deposits may create a fire hazard. Disassemble the reflector, unscrew the reflector spacer,

take off the screen, take down one side of protective guards. Then take the glass tube from the

heater and wash and clear. Reassemble the glass tube and the rest of parts.

Note: In a salt-air environment (such as near an ocean), corrosion occurs more quickly than normal.

Frequently check for corroded areas and repair them promptly.

Storage

Between uses:

• Turn control knob OFF.

• Disconnect LP cylinder.

• Store heater upright in an area sheltered from direct contact with inclement weather

(such as rain, sleet, hail, snow, dust and debris).

• If desired, cover heater to protect exterior surfaces and to help prevent build-up in air

passages.

Note: Wait until heater is completely cooled off before covering.

During periods of extended inactivity or when transporting:

• Turn control knob OFF.

• Disconnect LP cylinder and move to a secure, well-ventilated location outdoors.

• Store heater upright in an area sheltered from direct contact with inclement weather (such as rain,

sleet, hail, snow, dust and debris).

• If desired, cover heater to protect exterior surfaces and to help prevent build-up in air passages.

Never leave LP cylinder exposed to direct sunlight or excessive heat.

Note: Wait until heater is cool before covering.

Service

Only a qualified service person should repair gas passages and associated components.

Caution: Always allow heater to cool before attempting service.

ANS Z83.26-2007/CSA 2.37-2007 Gas-Fired Outdoor Infrared Patio Heaters

ANS Z83.26a-2008/CSA 2.37a-2008 Gas-Fired Outdoor Infrared Patio Heater

TIP:

Use high-quality automobile wax to help maintain the appearance of

your heater. Apply to exterior surfaces from upper support (long)

down. Do not apply to emitter screen or domes.