Owner's Manual

OPERATION INSTRUCTIONS

Caution: Do not attempt to operate

until you have read and understand all

General Safety Information in this

manual and all assembly is complete

and leak checks have been performed.

Before Turning Gas Supply ON:

1. Your heater was designed and approved for outdoor use only. Do NOT use it inside a building,

garage, or any other enclosed area.

2. Make sure surrounding areas are free of combustible materials, gasoline, and other flammable

vapors or liquids.

3. Ensure that there is no obstruction to air ventilation. Be sure all gas connections are tight and

there are no leaks.

4. Make sure the cylinder cover is clear of debris. Make sure any component removed during

assembly or servicing is replaced and fastened prior to starting.

Before Lighting:

1. Heater should be thoroughly inspected before each use, and by a qualified service person at least

annually. If relighting a hot heater, always wait at least 5 minutes.

2. Inspect the hose assembly for evidence of excessive abrasion, cuts, or wear. Suspected areas

should be leak tested. If the hose leaks, it must be replaced prior to operation. Only use the

replacement hose assembly specified by manufacturer.

Lighting:

Note: This heater is equipped with a pilot light that allows for safer startups and shutdowns. Pilot

must be lit before main burner can be started.

1. Turn the control knob to the “OFF” position.

2. Fully open LP cylinder valve.

3. Push control knob in and rotate to pilot position (Figure 1).

Note: For initial start or after any cylinder change, hold control knob in for 2 minutes to purge air

from gas lines before proceeding. After purging gas line please allow 5 minutes before attempting to

ignite heater.

• CARBON MONOXIDE HAZARD

• For outdoor use only. Never use inside house, or other

unventilated or enclosed areas. This heater consumes

air(oxygen). Do not use in unventilated or enclosed

areas to avoid endangering your life.

DANGER