Owners manual

OPERATION INSTRUCTIONS

Leak Check

To check for a leak:

1. Make 2-3 oz. leak check solution (one

part liquid dishwashing detergent

and three parts water).

2. Apply several drops of solution where

regulator connects to cylinder and to all

hose and valve connections

3. Make sure all patio heater and

light valves are OFF.

4. Turn cylinder valve ON.

If bubbles appear at any connection,

there is a leak.

1. Turn cylinder valve OFF.

2. If leak is at regulator/cylinder valve connection:

Disconnect, reconnect, and perform another

leak check. Apply the soapy solution to all hose and

valve connections. If you continue to see bubbles

after several attempts, cylinder valve is defective

and should be returned to cylinder’s place of

purchase.

3. If leak is at hose/regulator connection:

This part is defective and you should contact the

customer service department for replacement.

If NO bubbles appear at any connection, the connections are secure.

NOTE: Whenever gas connections are loosened or removed, you must perform a

complete leak test.

• Perform all leak tests outdoors.

• Extinguish all open flames.

• NEVER leak test when smoking.

• Do not use the heater until all connections have been

leak tested and do not leak.

WARNING