User Manual

ASSEMBLY INSTRUCTIONS
11
B
11. Assembly the protective guard and mesh
11
Insert the hooks of protective guard (H) to the
holes of upper supports (G).
H
Put the mesh (B) on the top plate (E).
FF
Make sure the screw holes align the holes of DD
top plate (E).Use Phillips screwdriver (LL) to
secure the mesh (B) and protective guard (H)
to the top plate (E) with M5 x 12 mm
screws (DD) and fixing bracket (FF).
Hardware Used
DD
M5 x 12 mm Screw
x 3
FF Fixing Bracket
x 3
Phillips
LL
Screwdriver
x 1
12. Carefully lean the assembly and attach
12
AA
reflector (A) to mesh (B) with studs (CC),
small flat washers (BB) on either side of
A
reflector (A) and then wing nuts (AA).
BB
Gently return the assembly to the upright
CC
position.
Hardware Used
AA
Wing Nut
x 3
BB
Small Flat
x 6
Washer
CC Stud x 3