User Manual

7
ASSEMBLY INSTRUCTIONS
3. Open the preassembled door (I) on cylinder
Housing (H) and place post (J) through the hole on
the top.
4. Secure post (J) to cylinder housing (H) using
the reinforced ring (NN), M6 x 10 mm bolts (DD)
and Φ6 small flat washers (EE). Fasten and cover
with the deck ring (OO).
Hardware Used
5. & 6. Slide fastening nut (G) down the post (J) with the rounded side facing down.
Next, slide the tightening spacer (F) down the post (J) with the smaller side facing down.
Put the table (E) on the post (J) with the metallic side facing up.
M6 x 10 mm
Bolt
Φ6 Small Flat Washer
Reinforced Ring
Deck Ring