User's Manual
Table Of Contents
- 1 About this Manual
- 2 Safety Instructions
- 3 Product Introduction
- 4 Installation Flow
- 5 Unpacking and Storage
- 6 Mechanical Installation
- 7 Electrical Connection
- 7.1 Safety Instructions
- 7.2 Port Introduction
- 7.3 Overview
- 7.4 Connecting to the Inverter
- 7.5 Connecting to the Meteo Station
- 7.6 Connecting to the Energy Meter
- 7.7 Wiring of DI Signal
- 7.8 Wiring of DO Signal
- 7.9 Wiring of AI Signal
- 7.10 Wiring of PT Signal
- 7.11 Connecting to the Remote Monitoring Device
- 7.12 Connecting to the AC Power Supply
- 7.13 Connecting to the DC Power Supply
- 7.14 Earthing Connection
- 8 Commissioning
- 9 Web Interface
- 9.1 Running Requirements
- 9.2 Login Steps
- 9.3 Web Main Interface
- 9.4 Operation Procedure
- 9.5 Overview
- 9.6 Device Monitoring
- 9.7 Device Maintenance
- 9.8 History Data
- 9.9 System
- 9.9.1 Running Information
- 9.9.2 System upgrade
- 9.9.3 Log export
- 9.9.4 Rebooting
- 9.9.5 Reset all setting
- 9.9.6 Remote Maintenance
- 9.9.7 Message Export
- 9.9.8 System Time
- 9.9.9 Forwarding Configuration
- 9.9.10 IEC104
- 9.9.11 MODBUS
- 9.9.12 Third-party portal
- 9.9.13 Forward GOOSE Service Configuration
- 9.9.14 Interface
- 9.9.15 MPLC
- 9.9.16 More
- 9.9.17 About
- 10 Grid Dispatching
- 11 Maintenance
- 12 Troubleshooting
- 13 FAQ
- 14 Appendix A: Technical Data
- 15 Appendix B: Related Drawings
- 16 Appendix C: General Information
86
PPrroottooccooll
DDeessccrriippttiioonn
FTP
The Logger4000 transfers the data of the collected
equipment (such as inverter, PV combiner box, Meteo
Station, etc.) to the remote monitoring system through
the FTP protocol.
MQTT
Logger4000 transfers the data collected from devices
(such as inverters, PV combiner box, Meteo Station,
etc.) to the remote monitoring system through the
MQTT protocol.
Q3. How to connect multiple Logger4000s to the background through the network?
1 Logger4000s closer to the Ethernet switch (＜100m) are connected to the Ethernet
switch by using network cables.
2 Logger4000s relatively far away from the Ethernet switch (＞100m) are connected
to the Ethernet switch by using routed fiber optic cables.
3 After cable connection, IP address of the multiple Logger4000s should be set to be
within the same network segment, without repeated addresses.
13 FAQ User Manual