User's Manual
Table Of Contents
- 1 About this Manual
- 2 Safety Instructions
- 3 Product Introduction
- 4 Installation Flow
- 5 Unpacking and Storage
- 6 Mechanical Installation
- 7 Electrical Connection
- 7.1 Safety Instructions
- 7.2 Port Introduction
- 7.3 Overview
- 7.4 Connecting to the Inverter
- 7.5 Connecting to the Meteo Station
- 7.6 Connecting to the Energy Meter
- 7.7 Wiring of DI Signal
- 7.8 Wiring of DO Signal
- 7.9 Wiring of AI Signal
- 7.10 Wiring of PT Signal
- 7.11 Connecting to the Remote Monitoring Device
- 7.12 Connecting to the AC Power Supply
- 7.13 Connecting to the DC Power Supply
- 7.14 Earthing Connection
- 8 Commissioning
- 9 Web Interface
- 9.1 Running Requirements
- 9.2 Login Steps
- 9.3 Web Main Interface
- 9.4 Operation Procedure
- 9.5 Overview
- 9.6 Device Monitoring
- 9.7 Device Maintenance
- 9.8 History Data
- 9.9 System
- 9.9.1 Running Information
- 9.9.2 System upgrade
- 9.9.3 Log export
- 9.9.4 Rebooting
- 9.9.5 Reset all setting
- 9.9.6 Remote Maintenance
- 9.9.7 Message Export
- 9.9.8 System Time
- 9.9.9 Forwarding Configuration
- 9.9.10 IEC104
- 9.9.11 MODBUS
- 9.9.12 Third-party portal
- 9.9.13 Forward GOOSE Service Configuration
- 9.9.14 Interface
- 9.9.15 MPLC
- 9.9.16 More
- 9.9.17 About
- 10 Grid Dispatching
- 11 Maintenance
- 12 Troubleshooting
- 13 FAQ
- 14 Appendix A: Technical Data
- 15 Appendix B: Related Drawings
- 16 Appendix C: General Information
81
FFaauulltt
PPoossssiibbllee ccaauussee
CCoorrrreeccttiivvee mmeeaassuurree
4. The PC cannot normally
receive data.
4. Use the shortcut key win+R
to call up the running
command box and enter "-
ping 12.12.12.12 (IP address
of the Logger4000)", to check
whether the PC can receive
data packets.
5. Confrontation with network
card or anti-virus software
occurs.
5. If the PC cannot receive
data packets, disable other
network cards, anti-virus
software or fireproof wall, and
try the login again.
Communication
failure between the
Logger4000 and
devices connected
to it
1. The RS485 cable
connecting the device and
the Logger4000 is abnormal.
1. Check the RS485 cable
connecting the device and
the Logger4000 and ensure it
is not in short circuit, open
circuit, or reverse connection
between RS485–A and
RS485–B.
2. Configuration of the serial
port is inconsistent with the
RS485 parameters of the
device.
2. Log into the Web, and click
“System”-＞”Port
Parameter“-＞”RS485“，
to check whether the port
configuration is consistent
with the RS485 parameters of
the device.
3. The current device is an
inverter, and the inverter
cannot be added to the Web
system in automatic search
manner.
3. Manually input the inverter
address to add the inverter to
the Web system.
User Manual 12 Troubleshooting