User's Manual
Table Of Contents
- 1 About this Manual
- 2 Safety Instructions
- 3 Product Introduction
- 4 Installation Flow
- 5 Unpacking and Storage
- 6 Mechanical Installation
- 7 Electrical Connection
- 7.1 Safety Instructions
- 7.2 Port Introduction
- 7.3 Overview
- 7.4 Connecting to the Inverter
- 7.5 Connecting to the Meteo Station
- 7.6 Connecting to the Energy Meter
- 7.7 Wiring of DI Signal
- 7.8 Wiring of DO Signal
- 7.9 Wiring of AI Signal
- 7.10 Wiring of PT Signal
- 7.11 Connecting to the Remote Monitoring Device
- 7.12 Connecting to the AC Power Supply
- 7.13 Connecting to the DC Power Supply
- 7.14 Earthing Connection
- 8 Commissioning
- 9 Web Interface
- 9.1 Running Requirements
- 9.2 Login Steps
- 9.3 Web Main Interface
- 9.4 Operation Procedure
- 9.5 Overview
- 9.6 Device Monitoring
- 9.7 Device Maintenance
- 9.8 History Data
- 9.9 System
- 9.9.1 Running Information
- 9.9.2 System upgrade
- 9.9.3 Log export
- 9.9.4 Rebooting
- 9.9.5 Reset all setting
- 9.9.6 Remote Maintenance
- 9.9.7 Message Export
- 9.9.8 System Time
- 9.9.9 Forwarding Configuration
- 9.9.10 IEC104
- 9.9.11 MODBUS
- 9.9.12 Third-party portal
- 9.9.13 Forward GOOSE Service Configuration
- 9.9.14 Interface
- 9.9.15 MPLC
- 9.9.16 More
- 9.9.17 About
- 10 Grid Dispatching
- 11 Maintenance
- 12 Troubleshooting
- 13 FAQ
- 14 Appendix A: Technical Data
- 15 Appendix B: Related Drawings
- 16 Appendix C: General Information
63
step 2 Set the initial status of DO to “NO” or “NC”, and click to set "Function", "Action
mode", and "Action time". Click
to save the settings.
step 3 If there is an external IO device connected to the logger, click "External" to set the DO
information of this device.
-- -- EEnndd
9.9.15 MPLC
step 1 Click "System"->"MPLC" to enter corresponding interface.
step 2 Click
on the operation bar to set information of master and slave nodes.
-- -- EEnndd
9.9.16 More
step 1 Click "System" -> "Port Parameters" -> "More" to enter the interface.
step 2 Select automatic online state (enable/disable) from the drop-down list.
• When the state is set to "Enable", parameters of string inverters researched and
developed by SUNGROW can be automatically added without additional operations
on the Web.
• When the state is set to "Disable", automatic parameter adding is not supported.
-- -- EEnndd
9.9.17 About
Click "About" to enter the corresponding interface.
Firmware information on Logger4000 can be accessed on this interface.
Scan QR code on the interface with the iSolarCloud App, to add new Logger4000.
User Manual 9 Web Interface