User's Manual
Table Of Contents
- 1 About this Manual
- 2 Safety Instructions
- 3 Product Introduction
- 4 Installation Flow
- 5 Unpacking and Storage
- 6 Mechanical Installation
- 7 Electrical Connection
- 7.1 Safety Instructions
- 7.2 Port Introduction
- 7.3 Overview
- 7.4 Connecting to the Inverter
- 7.5 Connecting to the Meteo Station
- 7.6 Connecting to the Energy Meter
- 7.7 Wiring of DI Signal
- 7.8 Wiring of DO Signal
- 7.9 Wiring of AI Signal
- 7.10 Wiring of PT Signal
- 7.11 Connecting to the Remote Monitoring Device
- 7.12 Connecting to the AC Power Supply
- 7.13 Connecting to the DC Power Supply
- 7.14 Earthing Connection
- 8 Commissioning
- 9 Web Interface
- 9.1 Running Requirements
- 9.2 Login Steps
- 9.3 Web Main Interface
- 9.4 Operation Procedure
- 9.5 Overview
- 9.6 Device Monitoring
- 9.7 Device Maintenance
- 9.8 History Data
- 9.9 System
- 9.9.1 Running Information
- 9.9.2 System upgrade
- 9.9.3 Log export
- 9.9.4 Rebooting
- 9.9.5 Reset all setting
- 9.9.6 Remote Maintenance
- 9.9.7 Message Export
- 9.9.8 System Time
- 9.9.9 Forwarding Configuration
- 9.9.10 IEC104
- 9.9.11 MODBUS
- 9.9.12 Third-party portal
- 9.9.13 Forward GOOSE Service Configuration
- 9.9.14 Interface
- 9.9.15 MPLC
- 9.9.16 More
- 9.9.17 About
- 10 Grid Dispatching
- 11 Maintenance
- 12 Troubleshooting
- 13 FAQ
- 14 Appendix A: Technical Data
- 15 Appendix B: Related Drawings
- 16 Appendix C: General Information
32
EEnneerrggyy
MMeetteerr
CCoommmmuunniiccaatt--
iioonn PPoorrtt
PPoorrtt
DDeeffiinniittiioonn
PPrroottooccooll
TTyyppee
WWiirriinngg MMeetthhoodd
Janitza
UMG604
22 RS485-B
Modbus
RTU
"7.6.1 RS485 Cable
Connection"
23 RS485-A
Ethernet Ethernet
Modbus
TCP
"7.6.2 Ethernet Cable
Connection"
7.6.1 RS485 Cable Connection
step 1 Lead the RS485 cable from the energy meter to the wiring area of the Logger4000.
step 2 Strip the protection layer and insulation layer of the communication cable with a wire
striper, as shown in the figure below.
step 3 Assemble proper cord end terminals to communication cable whose protective layer
and insulation layer are stripped off and crimp them with a crimping tool.
step 4 Connect the cable to the RS485 port of the Logger4000, as shown in the figure below.
-- -- EEnndd
7.6.2 Ethernet Cable Connection
Connect the "Ethernet" port of the energy meter and the "FE1~FE4" port of the Logger
with a network cable.
7 Electrical Connection User Manual