User's Manual
Table Of Contents
- 1 About this Manual
- 2 Safety Instructions
- 3 Product Introduction
- 4 Installation Flow
- 5 Unpacking and Storage
- 6 Mechanical Installation
- 7 Electrical Connection
- 7.1 Safety Instructions
- 7.2 Port Introduction
- 7.3 Overview
- 7.4 Connecting to the Inverter
- 7.5 Connecting to the Meteo Station
- 7.6 Connecting to the Energy Meter
- 7.7 Wiring of DI Signal
- 7.8 Wiring of DO Signal
- 7.9 Wiring of AI Signal
- 7.10 Wiring of PT Signal
- 7.11 Connecting to the Remote Monitoring Device
- 7.12 Connecting to the AC Power Supply
- 7.13 Connecting to the DC Power Supply
- 7.14 Earthing Connection
- 8 Commissioning
- 9 Web Interface
- 9.1 Running Requirements
- 9.2 Login Steps
- 9.3 Web Main Interface
- 9.4 Operation Procedure
- 9.5 Overview
- 9.6 Device Monitoring
- 9.7 Device Maintenance
- 9.8 History Data
- 9.9 System
- 9.9.1 Running Information
- 9.9.2 System upgrade
- 9.9.3 Log export
- 9.9.4 Rebooting
- 9.9.5 Reset all setting
- 9.9.6 Remote Maintenance
- 9.9.7 Message Export
- 9.9.8 System Time
- 9.9.9 Forwarding Configuration
- 9.9.10 IEC104
- 9.9.11 MODBUS
- 9.9.12 Third-party portal
- 9.9.13 Forward GOOSE Service Configuration
- 9.9.14 Interface
- 9.9.15 MPLC
- 9.9.16 More
- 9.9.17 About
- 10 Grid Dispatching
- 11 Maintenance
- 12 Troubleshooting
- 13 FAQ
- 14 Appendix A: Technical Data
- 15 Appendix B: Related Drawings
- 16 Appendix C: General Information
27
• The Logger4000 supports 6 RS485 buses and 200 devices at most. Each RS485
bus supports 80 devices at most.
• Devices of different types must be connected to different RS485 communication
ports of the Logger4000. For example, the transformer and the inverter should be
connected to different RS485 communication ports of the Logger4000.
• The address of each device on the RS485 bus should be within the set address
range (1 to 246) of the Logger4000 without repetition. Otherwise, communication
failure occurs.
• Serial port parameters of each device on the RS485 bus should be consistent with
those of the Logger4000. The serial port parameters include baud rate, data bit, stop
bit, and check bit.
CCoonnnneeccttiioonn PPrroocceedduurree
step 1 Lead the RS485 communication cable from the inverter to the wiring area of
Logger4000.
step 2 Strip the protection layer of the communication cable with a wire stripper. Cable
specification and stripped length are as follows:
step 3 Assemble proper cord end terminals to communication cable whose protective layer is
stripped off and crimp them with a crimping tool.
User Manual 7 Electrical Connection