User's Manual
Table Of Contents
- 1 About this Manual
- 2 Safety Instructions
- 3 Product Introduction
- 4 Installation Flow
- 5 Unpacking and Storage
- 6 Mechanical Installation
- 7 Electrical Connection
- 7.1 Safety Instructions
- 7.2 Port Introduction
- 7.3 Overview
- 7.4 Connecting to the Inverter
- 7.5 Connecting to the Meteo Station
- 7.6 Connecting to the Energy Meter
- 7.7 Wiring of DI Signal
- 7.8 Wiring of DO Signal
- 7.9 Wiring of AI Signal
- 7.10 Wiring of PT Signal
- 7.11 Connecting to the Remote Monitoring Device
- 7.12 Connecting to the AC Power Supply
- 7.13 Connecting to the DC Power Supply
- 7.14 Earthing Connection
- 8 Commissioning
- 9 Web Interface
- 9.1 Running Requirements
- 9.2 Login Steps
- 9.3 Web Main Interface
- 9.4 Operation Procedure
- 9.5 Overview
- 9.6 Device Monitoring
- 9.7 Device Maintenance
- 9.8 History Data
- 9.9 System
- 9.9.1 Running Information
- 9.9.2 System upgrade
- 9.9.3 Log export
- 9.9.4 Rebooting
- 9.9.5 Reset all setting
- 9.9.6 Remote Maintenance
- 9.9.7 Message Export
- 9.9.8 System Time
- 9.9.9 Forwarding Configuration
- 9.9.10 IEC104
- 9.9.11 MODBUS
- 9.9.12 Third-party portal
- 9.9.13 Forward GOOSE Service Configuration
- 9.9.14 Interface
- 9.9.15 MPLC
- 9.9.16 More
- 9.9.17 About
- 10 Grid Dispatching
- 11 Maintenance
- 12 Troubleshooting
- 13 FAQ
- 14 Appendix A: Technical Data
- 15 Appendix B: Related Drawings
- 16 Appendix C: General Information
16
Only undamaged Logger4000 can be installed and commissioned. Before
installation, ensure that:
• The Logger4000 is intact without any damages.
• Related documents, such as quick user manual, are enclosed.
5.4 Storage
If the Logger4000 is not to be installed immediately after receiving, observe the
following requirements to store it properly:
• The Logger4000 should be store in its original packing case and placed in a well-
ventilated, dry, and tidy room.
• The storage carrier should be suitable for the weight of the Logger4000.
• The storage environment should be well ventilated, dry, and without any
accumulated water.
• Ambient temperature: -40℃ to +70℃; relative humidity: 0~95%, no condensation.
• Take precautions to protect the device against damage due to harsh environment
such as shock cooling, shock heating, and collision.
• Regularly inspect the Logger4000, usually at least once a week. Check the packing
case for intactness and replace it immediately when necessary.
• Unpack and check the Logger4000 in powered on state if it has been stored more
than half a year.
• The Logger4000 must be packed during storage!
• Never store the Logger4000 outdoors or in a place directly exposed to!
• No tilting or stacking!
After long-time storage, thoroughly check the Logger4000 and ensure it is
undamaged before installation. If necessary, install the Logger4000 only after
it has been tested by qualified personnel.
5 Unpacking and Storage User Manual