User's Manual
Table Of Contents
- 1 About this Manual
- 2 Safety Instructions
- 3 Product Introduction
- 4 Installation Flow
- 5 Unpacking and Storage
- 6 Mechanical Installation
- 7 Electrical Connection
- 7.1 Safety Instructions
- 7.2 Port Introduction
- 7.3 Overview
- 7.4 Connecting to the Inverter
- 7.5 Connecting to the Meteo Station
- 7.6 Connecting to the Energy Meter
- 7.7 Wiring of DI Signal
- 7.8 Wiring of DO Signal
- 7.9 Wiring of AI Signal
- 7.10 Wiring of PT Signal
- 7.11 Connecting to the Remote Monitoring Device
- 7.12 Connecting to the AC Power Supply
- 7.13 Connecting to the DC Power Supply
- 7.14 Earthing Connection
- 8 Commissioning
- 9 Web Interface
- 9.1 Running Requirements
- 9.2 Login Steps
- 9.3 Web Main Interface
- 9.4 Operation Procedure
- 9.5 Overview
- 9.6 Device Monitoring
- 9.7 Device Maintenance
- 9.8 History Data
- 9.9 System
- 9.9.1 Running Information
- 9.9.2 System upgrade
- 9.9.3 Log export
- 9.9.4 Rebooting
- 9.9.5 Reset all setting
- 9.9.6 Remote Maintenance
- 9.9.7 Message Export
- 9.9.8 System Time
- 9.9.9 Forwarding Configuration
- 9.9.10 IEC104
- 9.9.11 MODBUS
- 9.9.12 Third-party portal
- 9.9.13 Forward GOOSE Service Configuration
- 9.9.14 Interface
- 9.9.15 MPLC
- 9.9.16 More
- 9.9.17 About
- 10 Grid Dispatching
- 11 Maintenance
- 12 Troubleshooting
- 13 FAQ
- 14 Appendix A: Technical Data
- 15 Appendix B: Related Drawings
- 16 Appendix C: General Information
15
NNoo.. NNaammee
DDeessccrriippttiioonn
J
Tapping screw assembly 8, including ST4.8x19 expansion bolts and
tapping screws, used for wall-mounted
installation
K
Fastener assembly
6, M4x8 cross recessed countersunk head
screws, used to anchor the mounting ears to the
Logger4000
5.2 Identifying the Logger4000
The type and key technical parameters of the Logger4000 can be found on the
nameplate. The nameplate is attached to the upper right corner of the Logger4000,
shown by A in the figure below.
The nameplate contains important parameters. Ensure it is intact and clearly
legible.
5.3 Checking upon Receiving
The Logger4000 is thoroughly inspected and packed before delivery, but damage may
be still caused during transport. Check the following items carefully once receiving the
Logger4000.
• Check the scope of delivery for completeness according to "5.1 Scope of Delivery".
• Ensure that the device type is correct.
• Check the device thoroughly and ensure there are no visible damages.
If there are any problems, contact SUNGROW or the forwarding company.
User Manual 5 Unpacking and Storage