Installation Guide

[HG] x 2 [S3] x 4

DOOR 5

[HG]

1. Bend the [HG] hinge before nailing it to the door. No tool is required.

2. Take a closer look at [HG], which has two sides. The dierence is that there are

ve countersunk screw holes on Side A. While nailing [HG] to the door, make

sure that [S3] goes into the countersunk screw holes. No [S4] is required.

[HG] Side A [HG] Side B

COMMON MISTAKE: [HG]

Aside from the countersunk screw holes, there is another catch about [HG]. After this

step is done, the wing of [HG] should stick out to the exterior of the door. Another

indicator is the crescent opening on [HG]. If done correctly, the opening points to the

interior of the door, like the picture on the left below.

[Countersunk

Screw Hole]