Installation Guide

[W2] x 1 [S3] x 4 [S4] x 4

ROOF PANELS 1

BACK

L-Channel

[W2]

Start from this [W2] rst. Some key points:

1. Place the [W2] so that the L-channel points to the out-

side of the shed, not inside. This is important.

2. Only four sets of [S3]+[S4] are used. The order of xing

these four sets are irrelevant, but you need to make

sure that the [S3] are indeed going into the screw

holes on the triangular panel or top frames.

3. The ten Screw holes on the ribs are not used in this

step.